SMR Gearbox Set up
Satisfactory overall performance depends upon appropriate set up. lubrication and upkeep. therefore it is vital that the instructions while in the set up and upkeep leaflet. supplied with each gearbox. are followed carefully. some of the important facets of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as shut on the reducer probable, and mount reducer on driven shaft as close to bearing as practical. failure to carry out this may induce extra loads within the input shaft bearings and output bearings and could cause their premature failure.
two. Install motor and wedge belt drive using the belt pull at approximately 90° to your center line in between driven and input shafts. this may permit tensioning of the wedge belt drive together with the torque arm which need to preferably be in stress. if output hub runs anti-clockwise. torque arm really should be positioned the right.
three. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm will likely be at approximately right angles to your center line through the driven shaft and also the torque arm situation bolt. make sure there is certainly enough consider up during the turnbuckle for belt stress adjustment.
Maintain near.
Bell drive could possibly be found in any effortless postion. should the torque arm is always to be applied to tighten the belts, the drive should be at about tight angle for the line concerning the input and output shafts.
Bell drive can be positioned to the proper if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that shown in the illustration.
Torque arm and belt take up.
Torque arm can be mounted to your ideal if preferred.