Power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is built exclusively to the modest lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has become broadly made use of from the business of logistic units including minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed by the solenoid valve together with the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Standard Description
This energy unit is designed exclusively for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the speed managed through the adjustable needle valve. Once the lift rises to a high positoin, but the energy supply is reduce, the reducing movement is controlled through the manual override perform.
Power UNITS FOR LIFT TABLE 3
Standard Description
This electrical power unit is created exclusively for the huge lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the speed controlled by a stress compensated movement management valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This electrical power unit is developed exclusively for your large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the speed managed by the adjustable needle valve. When the lift rises to a higher positoin, but the energy supply is reduce, the decreasing motion is controlled from the guide override function.
Specific Notes
1. This electrical power unit is of S3 duty cycle, which can only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned prior to set up of the power unit.
three. Viscosity on the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. Oil modifying is needed immediately after the initial 100 operation hrs,afterwards after each 3000 hours.
five. The electrical power unit proven is created to be mounted vertically.